Search found 3 matches
- Wed Nov 11, 2020 2:35 pm
- Forum: Problems and questions
- Topic: Post processor advice
- Replies: 0
- Views: 4810
Post processor advice
Running a Messer plasma machine that's approximately 15 years old. I primarily run 200 and 260 amp torches. All torches are hypertherm xd. I believe the nesting software is Omniflow but cannot seem to find the name anywhere. Only that it is Global Control? I am trying to figure out the correct (or b...
- Thu Nov 05, 2020 7:39 pm
- Forum: Problems and questions
- Topic: Sheetcam Settings
- Replies: 2
- Views: 620
Re: Sheetcam Settings
On it! Thank you very much for taking the time to help me out. Greatly appreciated!
- Thu Nov 05, 2020 7:18 am
- Forum: Problems and questions
- Topic: Sheetcam Settings
- Replies: 2
- Views: 620
Sheetcam Settings
Just purchased sheetcam to use in conjunction with Inkscape. Running a fairly large Messer Plasma Table that uses OmniFab cam software. Played with the settings and it took a bit but managed to burn some test parts. Have since tinkered with the settings and have regressed. I tried deleting sheetcam ...