sheetcam.com

I’ve created code snippets for M205 through M214. I’ve been busy turning them into path rules 1 or 2 at a time. Then I run the post processor and look at the resulting .tap file to see how it changed. This is helping me understand how each M code added as a path rule changes the output. Interestingl...

Les, you are friggin awesome! That was it! Fixed. Its been driving me crazy. One little checkbox. Thank you. You’re the best.

Scott

I must have something going on I don’t understand. I have path rules set to none. Where else would this be coming from?

I tried the UCCNC Plasma post processor and I'm still having issues. M205 and M206 are still being added throughout the g-code. See below: N0010 (Filename: Test - TEST 4 inch UCCNC Plasma v1.tap) N0020 (Post processor: UCCNC plasma.scpost) N0030 (Date: 7/22/2021) N0040 G21 (Units: Metric) N0050 G53 ...

Thanks Les,

I’ll take a closer look at that one. I had looked into it before, but didn’t notice the G31 way down in there.

All the best,

Scott Meer

Is there a UCCNC Post Processor for Plasma with settings for G31 touch off and absolutely no THC functionality in it ? I want to write my own sheetcam path rules to control the THC better. I've tried disabling THC in a few post processors using the editor and the recommended "nil" entry, b...