Search found 7 matches

by pgilley
Sat Jun 22, 2019 5:25 pm
Forum: Problems and questions
Topic: Sheetcam tools
Replies: 4
Views: 125

Re: Sheetcam tools

Have done that. When reopen sheetcam the tools are back on.
by pgilley
Sat Jun 22, 2019 12:16 am
Forum: Problems and questions
Topic: Sheetcam tools
Replies: 4
Views: 125

Sheetcam tools

I have several unused tools on sheetcam. Would like to permanently remove them. Anyone have directions to do this ?
by pgilley
Sun May 19, 2019 11:26 pm
Forum: Problems and questions
Topic: Update to sheetcam
Replies: 2
Views: 473

Re: Update to sheetcam

Rather old post. Just happened to see it and realized that I had the same problem and found that if you click on HELP in Sheetcam there is an place for checking and updating Sheetcam.
by pgilley
Sun May 19, 2019 11:13 pm
Forum: Problems and questions
Topic: Sheetcam and arc leadin
Replies: 4
Views: 463

Re: Sheetcam and arc leadin

Thanks for the reply. I will change the pierce delay and see. I did not do any of the drawing on this file. Came from a dxf file from a friend. When I initially cut this pattern it worked great. Just started doing some of the weird stuff after quiet some time of use. Over time I had cut several of t...
by pgilley
Fri May 17, 2019 9:38 pm
Forum: Chat
Topic: Cutmaster 60i
Replies: 1
Views: 139

Cutmaster 60i

Anyone using the Esab Cutmaster 60i on a plasma table ? I am using a Cutmaster 52 (Radnor version) and the duty cycle shuts down at times. Some cuts run about 20 minutes. Just wondering if my 1Torch on the 52 will work on the 60i ? I am using the 1Torch hand torch wired directly to the trigger switc...
by pgilley
Fri May 17, 2019 9:24 pm
Forum: Problems and questions
Topic: Sheetcam and arc leadin
Replies: 4
Views: 463

Re: Sheetcam and arc leadin

Not very good with PC. Will try to send file.
by pgilley
Tue May 14, 2019 11:20 pm
Forum: Problems and questions
Topic: Sheetcam and arc leadin
Replies: 4
Views: 463

Sheetcam and arc leadin

In some DXF files the plasma torch sets down for cut, then moves about lead in arc length without cutting. torch then starts cut and stops cut about lead in length before finishing cut. Works great on most files.