sheetcam.com

It was suggested from someone else on the Langmuir forum to adjust the pierce height because of it being aluminum which dissipates heat faster. I did that and increased the pierce delay and I’m getting a clean start now. Just wish it had more height to keep aluminum blowing back on the nozzle. So my...

I’ll try to tomorrow when I’m at my shop.

I don’t think so. It does this on all the files I’ve made. Since I’ve changed over to this cut45. I’m beginning to think it’s the cutter. Possibly going to put my hypertherm cutter on and see. Reason I haven’t yet is I wanted to see how this cut45 does. Only way I can make it a complete cut is using...

Having issue with piercing. No matter what I set my pierce delay at it doesn’t start the cut until after it starts moving and leaves just a small nib. I’ve set it at .5, 1 and 3 seconds. Same thing each time. For me to cut the nib I have to use overcut. I’ve tried different files with the same resul...

I’m trying to bring an Inkscape svg into sheetcam. When I import it I set drawing options I put scaling at 1:1 and hit ok. It never loads the file. I’ve tried saving the svg as an Inkscape svg and a plain svg. If I save as a Dxf it will load but I have to scale it to the size I need. I’m using windo...

I have hypertherm toolset on my personal plasma table and have just been allowed to use my pc on another another table that has a razorweld. My question is can I set my pc up to where I can have two separate toolsets for two different machines? If how do I go about it. Thanks for a reply.

Ok i figured it out. I’m not sure if its an issue with inkscape or sheetcam. One of them will not recognize a .750 hole. I dropped down to .625 and it showed up full circle.

I seem to have developed an issue. I use inkscape for drawing up files. I make sure of no open lines. Save the file. Bring it into sheetcam and only half of the hole shows up. Has done this on three different files tonight. I have deleted the hole renamed it saved the file. Opened a new window broug...

Found it Thanks. Now is there a way to save it how i want it nested? So i dont have to break it up every time i load it in sheetcam.

I downloaded a dxf and it came in 6pcs to cut and are spread out apart from each other. Is there a way in sheetcam to break up or separate the pieces so that i can nest them close to one another? The overall actual size of the file is bigger than my 4x4 table. Still learning sheetcam just dont know ...

I got a new pc and wonder if my sheetcam license can be transferred to it. Is it allowed?

Just bought the license on 3/10. When i try to run a simulation it tells me Warning feed rate at zero. Post processing completed with one warning. What is going on?