Search found 5 matches

by AZ_GUY
Tue Mar 26, 2019 7:46 pm
Forum: Problems and questions
Topic: x and y reversed
Replies: 5
Views: 3973

Re: x and y reversed

Assuming Mach3 since you haven't stated. You should have one of the dual drive motors (probably A) set to reversed in the soft limits. Then to change direction go to Config --> Ports and Pins --> Motor Outputs and then change Dir LowActive to reverse the direction. You can also reverse the travel d...
by AZ_GUY
Sat Mar 23, 2019 5:14 am
Forum: Problems and questions
Topic: x and y reversed
Replies: 5
Views: 3973

Re: x and y reversed

Thanks I didn’t think about that, I thought both motors just got the same input. So does that sound right? Just reverse the x and y the same way I did the z in the soft limits section of the settings?
by AZ_GUY
Fri Mar 22, 2019 8:43 pm
Forum: Problems and questions
Topic: x and y reversed
Replies: 5
Views: 3973

x and y reversed

I have a 4x4 table and the X and Y are going the wrong directions. I think the guy I bought the table from had it set up 180 degree different than i do, for example if I jog with the left arrow the torch moves right, etc..how can I reverse that? I tried reversing it the same way ive seen to reverse ...
by AZ_GUY
Sun Mar 10, 2019 4:18 am
Forum: Problems and questions
Topic: License for 2 computers
Replies: 1
Views: 3391

License for 2 computers

I posted up a topic asking about the “warning feed rate zero” and I’m 90 percent sure it’s just because I tried to copy the license to my laptop. Is there a way I can use the same license for my pc and laptop? It’s just me using both machines but the pc is old and slow so I’d rather have it on my la...
by AZ_GUY
Sun Mar 03, 2019 11:18 pm
Forum: Problems and questions
Topic: Warning feed rate is zero
Replies: 0
Views: 10581

Warning feed rate is zero

I bought a CNC plasma table with a computer. I have been using everything and everything has been working great but the PC is old and feel like its about to fail. I tried to move everything to my laptop and copied my sheetcam license. It worked great on my laptop for about a day but now its not work...