Search found 6 matches
- Thu Jun 04, 2020 12:36 pm
- Forum: Problems and questions
- Topic: Not Creating G Code
- Replies: 7
- Views: 1301
Re: Not Creating G Code
Sent a PM
- Wed Jun 03, 2020 10:09 pm
- Forum: Problems and questions
- Topic: Not Creating G Code
- Replies: 7
- Views: 1301
Re: Not Creating G Code
Your correct I have TNG, didnt realize. Attached is a part job file and the code I get when i run the post processor. Thanks
- Wed Jun 03, 2020 3:03 pm
- Forum: Problems and questions
- Topic: Not Creating G Code
- Replies: 7
- Views: 1301
Re: Not Creating G Code
Is Sheetcam TNG an upgrade over standard sheetcam I have, or will it in the future? If so Ill just buy that to get going.
- Wed Jun 03, 2020 2:42 pm
- Forum: Problems and questions
- Topic: Not Creating G Code
- Replies: 7
- Views: 1301
Re: Not Creating G Code
Yes, Ive triple checked that I have created cut operations. Ive tried pulling up other parts and doing new files and the same thing happened.
My next step was to uninstall and reinstall sheetcam. Ive been down three days and I have work piling up so Im getting a little desperate.
My next step was to uninstall and reinstall sheetcam. Ive been down three days and I have work piling up so Im getting a little desperate.
- Tue Jun 02, 2020 1:28 am
- Forum: Problems and questions
- Topic: Not Creating G Code
- Replies: 7
- Views: 1301
Not Creating G Code
I have a Wright CNC plasma table, had my Sheet cam running fine since Jan 2019. Yesterday I went to use it after a power outage. I was able to put 3 parts on a sheet generate code and cut them. Then when I went to do more parts on the same sheet I started having issues where the parts on my screen d...
- Sat Jan 05, 2019 11:39 pm
- Forum: Problems and questions
- Topic: Sheetcam not writing g code
- Replies: 11
- Views: 8035
Re: Sheetcam not writing g code
I am having this exact same issue. Was able to make about a dozen files then it started doing the same lines as shown and not writing the part code. I will PM you the same issue.
Machine is a Wright CNC, using Mach 3.
Machine is a Wright CNC, using Mach 3.