Search found 5 matches

by Forrest
Tue Feb 05, 2019 1:12 am
Forum: Problems and questions
Topic: Problems with Linux command CNC after switching to new computer
Replies: 6
Views: 4264

Re: Problems with Linux command CNC after switching to new computer

Ok guys, I think I got it fixed. The code that was being generated from the tool set for THC on/off was wrong. I figured it out by re-reading the Candcnc manual for Sheetcam Linux setup and by comparing the old codes I had to the new ones. I ran one test and it seems like its back to normal. I will ...
by Forrest
Mon Feb 04, 2019 11:09 pm
Forum: Problems and questions
Topic: Problems with Linux command CNC after switching to new computer
Replies: 6
Views: 4264

Re: Problems with Linux command CNC after switching to new computer

The NAME of the cut rules may be the same, but the CODE in the cut rules can be different between Windows/Mach and Linux. I went from Mach to CommandCNC as well. Initially, I didn't use any rules at all, but I've slowly started adding them back in. Torch off before end, slowdowns at sharp corners, ...
by Forrest
Fri Feb 01, 2019 11:44 pm
Forum: Problems and questions
Topic: Problems with Linux command CNC after switching to new computer
Replies: 6
Views: 4264

Problems with Linux command CNC after switching to new computer

I have been running Sheetcam and a Candcnc mp3600 THC on Linux for almost 2 years now. Everything was working great until I recently. I got a new laptop and this is where I run Sheetcam (separate from the Linux computer). After downloading the most recent version of Sheetcam to the new laptop and ma...
by Forrest
Tue Dec 04, 2018 8:25 pm
Forum: Problems and questions
Topic: Anything Better Than CorelDraw For Vector Graphics?
Replies: 3
Views: 2013

Re: Anything Better Than CorelDraw For Vector Graphics?

I use the smart fill tool in Corel a lot to make a "new copy" of the object. This insures that i have a clean image. Say you draw a rectangle with a circle in the middle. I use smart fill on top of this object to make a new object usually using a different color so its easy to see. Then de...
by Forrest
Tue Dec 04, 2018 8:17 pm
Forum: Problems and questions
Topic: Tried to move LIcence file to new computer, now not working
Replies: 0
Views: 3927

Tried to move LIcence file to new computer, now not working

Hi, I have been running sheetcam for a couple years now just fine. I got new computer and tried to move the license file to the new computer via USB. I copied the license file to the usb for old computer and uploaded to the new computer. It said the license file had been installed and to restart she...