Search found 3 matches
- Mon Dec 11, 2023 1:45 pm
- Forum: Problems and questions
- Topic: Pause after rapid move?
- Replies: 6
- Views: 4963
Re: Pause after rapid move?
well, if you did that, you're going to "race against time" to get that part out before motion resumes. I suspect there some cases in which you loose :( Is it possible instead to install Pause and Resume pushbuttons on your control panel so that you control the motion stop and start ? I do...
- Thu Dec 07, 2023 5:27 pm
- Forum: Problems and questions
- Topic: Pause after rapid move?
- Replies: 6
- Views: 4963
Pause after rapid move?
I am wondering if there is a way to have my machine pause "before the next cut". I understand that I can use the "pause at the end of cut" but that doesn't give me access to the most recent cut piece. I would really like to pause after the torch raises and moves to next location....
- Fri Nov 08, 2019 3:38 pm
- Forum: Problems and questions
- Topic: first lead in wrong side
- Replies: 0
- Views: 9792
first lead in wrong side
Has anyone ever run into this problem? Doesn't happen all the time and doesn't even happen all the time on the same file.... Lets say its a word being cut, the lead ins are all good on screen processing inside cuts first with proper leads then outside cuts. Load into mach3 and start cut. First cut (...