sheetcam.com

Why is there only a 64-bit version on the download official page - 7.1.20-1-amd64 ? I need the last update 32-bit version in branch 7.1. This will eventually run on Debian 7 Wheezy with LinuxCNC 2.6.12.

Will you show some screenshots ?

The program works, but the graphical interface is ugly. Windows are not displayed correctly and it is not possible to widen them. Some of the functions are cut off and they are invisible due to errors in displaying windows.

I need to remove the previous version 6.1.57 before installing new version 7.1.16 ? Installation with a BIN file.

Please a link to the latest version 32-bit. 7.1.16 or 7.1.17 ? " To install it, download the file then right-click on it an select 'properties'. Go to the permissions tab and make sure 'execute' is turned on. You can now simply double click on the file to install SheetCam. If that does not work...

Will it run on Debian 7 Wheezy 32-bit ???

Hello. When did SheetCam TNG update for Linux system ? Rev. 6.1.57 is a little old now. A very long time ago there was no update

You should get a license file to the email address.

When cutting with plasma cnc.

M09 - all corners, smaller holes, arcs with a smaller radius, short lines [was it thc off]
M08 - all the rest [was it thc on]

thcOnCode = " M09"
thcOffCode = nil

I will check on this.

OK, how to define thcOnCode ? Also nil command/delete this from the post processor ?

thcOnCode = ????
thcOffCode = nil

Good morning all. I would like to enable THC permanently. Now I have set up like this - thcOnCode = " M08", thcOffCode = " M09". THC does not work all the time, with M09 it turns off.

CAM - SheetCam TNG 6.1.53
CNC controller - LinuxCNC
postprocessor - LinuxCNC THC