sheetcam.com

I've been running my table for a few years now with this problem but haven't really cared to fix it til now. When cutting a part that has outside and inside profiles, the outside comes out with perfect dimensions. The inside however tends to have more of an offset than it should, causing all my insi...

I will try that. I will name it plasmadrill and see what happens.

here is an example

Hey motoguy, not sure about the other situations but looping corners is an easy fix. Just use a path rule on corners. Set up your code to shut of thc prior to the corner and come on after.

I've gotten it to work with adding a pierce delay. So I can deal with that. Just would like to figure out what is not exactly right. Kinda like algebra, if one step isn't exact then maybe the next won't work at all.

There is a plasmadrill set to one. I agree it is something to do with my toolset and operation vs the post.

At the end of "pen down" there is a section for, else -- not a marker or drill tool or plate engraver. I am 85% sure my stuff is falling in here. With that said, I went back and added a pierce delay to my T6 centerpunch tool. It added a pause. So this should work, but it still isn't right....

I agree it's something like that, but I don't know any options to fix it. This seems to be the correct route but I don't see any optional tool types or if it is the operation. Either way, just not sure what avenue to take from here. In the post it shows the correct operation if it is a drill tool. I...

I am having an issue with marking points with my plasma cutter for manual drilling. The operation consists of putting drilling points on another layer, and creating a drill operation with "CenterPunch" tool. Problem comes with the second center punch. First punch the torch fires for a mome...