Search found 8 matches
- Mon Feb 12, 2018 9:04 pm
- Forum: Problems and questions
- Topic: edge starting a part.
- Replies: 4
- Views: 1548
Re: edge starting a part.
OK Thanks Les.
- Mon Feb 12, 2018 10:23 am
- Forum: Problems and questions
- Topic: edge starting a part.
- Replies: 4
- Views: 1548
Re: edge starting a part.
Thanks for the response but not quite what I had in mind. I take your point though. I'll try again. Lets say I have a piece of 200mm wide flat bar which is coincidentally the same width of the part I wish to cut. So all I need to do is cut the ends. How can I remove the 2 sides from the cut list wit...
- Sun Feb 11, 2018 10:21 am
- Forum: Problems and questions
- Topic: edge starting a part.
- Replies: 4
- Views: 1548
edge starting a part.
I am sure this has been covered somewhere but the answer eludes me. If I want to plasma cut a square for example from material that is too thick to pierce but not too thick to edge start, how can I configure sheetcam to not cut the edges which align with the edge of the material? Thanks in advance, ...
- Sun Dec 10, 2017 8:04 pm
- Forum: Problems and questions
- Topic: GRBL Post processor for Sheetcam
- Replies: 17
- Views: 12327
- Sun Dec 10, 2017 1:11 pm
- Forum: Problems and questions
- Topic: GRBL Post processor for Sheetcam
- Replies: 17
- Views: 12327
It looks like somehow you are missing a chunk of the post code. That should be line 204. Try downloading and installing it again. Thanks for your response Les. It is line 204 in the GRBL THC with scriber.scpost but it shows up as line 84 in the plain GRBL plasma.scpost Using the same tool and opera...
- Sat Dec 09, 2017 10:07 pm
- Forum: Problems and questions
- Topic: GRBL Post processor for Sheetcam
- Replies: 17
- Views: 12327
- Sat Dec 09, 2017 9:00 pm
- Forum: Problems and questions
- Topic: GRBL Post processor for Sheetcam
- Replies: 17
- Views: 12327
- Wed Dec 06, 2017 8:44 pm
- Forum: Problems and questions
- Topic: GRBL Post processor for Sheetcam
- Replies: 17
- Views: 12327