sheetcam.com

No problem sir. I checked what you said and it's at .0004 My lines are not that small. They vary from an inch to longer. Not sure if I understood that correctly. Tks

I have this eagle who has a lot of lines in it. I made the sign with Coral Draw and in my drawings I cannot find anything wrong with the file. In sheetcam, it's closing all the open lines to closed shapes. Not sure what i'm doing wrong. Even if I try with no offset.

I tried to clean up the file and now I do not have an X as a warning but just the yellow sign. It says that some areas are too small for a lead in and that's fine but places overlap and were fixed by Sheetcam. I checked and rechecked and the lines do not overlap anywhere. Only place I can see is som...

Hello, just bought Sheetcam and trying to learn how it works. First I have a Tracker CnC 4x4 and the Command N Cut software that came with it. I'm using this software to load the sheetcam file and cut it. I'm trying to cut stuff for signs. If it's regular shapes, circles, squares, and cutting for a ...

Mr. Wyogreen mentionned to load the saved processed file into my controller and cut with it. I tried to find what am I suppose to open as a software for the controller but a Tracker comes with only the Command n cut software. If I take it to open the new G-code.plt file it still cuts the same as if ...

Can you or can't u cut something in the trial version. I know it's for a limited amount of g-code lines but I wanted to cut this to play with the software. Tks

Trying to test out Sheetcam with my Tracker CNC. I am using Corel x7 for drawing and made an L bracket to play with. I did the simulation and everything is good to go. Last thing I did was to run the post processor. It's saving it and then says post completed. Is it suppose to start cutting then? Wh...

Cool, did that and installed it in sheetcam. Thank you very much.

Hello guys, newbie here about plasma cutting. I have a Tracker CNC 4x4 table working with Corel Draw and Command n Cut software to cut. Command n Cut is extremely basic and would like to upgrade. I read that Sheetcam is extremely popular for plasma cutting. I downloaded the trial version and install...