Search found 7 matches

by Plasmalex
Wed Feb 22, 2017 5:09 pm
Forum: Problems and questions
Topic: Floathing head plasma setting ?
Replies: 0
Views: 3701

Floathing head plasma setting ?

Hi ! I'm running cnc plasma that i build . Using mach 3 and sheetcam. I've install my floating head but thats doesnt work . I've try mach3 plasma thc with scribber post and also try MP1000-THC-scriber post. Anyone work . I've set my floating head switch as homing z . When i click homing that work , ...
by Plasmalex
Wed Feb 08, 2017 11:59 am
Forum: Problems and questions
Topic: Proma thc with mach3 issues .. post processor?
Replies: 4
Views: 1794

Ok thanks Les !!
by Plasmalex
Tue Feb 07, 2017 9:16 pm
Forum: Problems and questions
Topic: Proma thc with mach3 issues .. post processor?
Replies: 4
Views: 1794

Yes he show the correct voltage , i've set the HU ( high voltage limit of thc) to 300v and that work .. i don't know why but its working.. thank for reply ! I look to install floating head next week, so the apropriate post processor should be wish one ?
by Plasmalex
Tue Feb 07, 2017 12:32 am
Forum: Problems and questions
Topic: Proma thc with mach3 issues .. post processor?
Replies: 4
Views: 1794

Proma thc with mach3 issues .. post processor?

Hi, i 've install my new thc from proma . I wired all wire and when i try "test mode " thats work perferctly , my z axis works up and down . When i try to cut some piece, the torch pierce and stay at this position . I have to e-stop .... I've test with multimeter and i have +/- 130v. I don...
by Plasmalex
Fri Dec 30, 2016 10:53 pm
Forum: Problems and questions
Topic: Cut size problem
Replies: 4
Views: 1416

I do the test off 10x10 square and I think mach 3 doesnt read the offset of the tool , i've try to change the tool diameter and its same size , i think the problem is on mach3 setting , the g code is ok .
by Plasmalex
Fri Dec 30, 2016 11:48 am
Forum: Problems and questions
Topic: Cut size problem
Replies: 4
Views: 1416

Thanks for reply, yes Ive do the test and the machine move exacly 10 inch on jog for alll axis , but when I open g code ,cut larger than draw😯
by Plasmalex
Fri Dec 30, 2016 10:10 am
Forum: Problems and questions
Topic: Cut size problem
Replies: 4
Views: 1416

Cut size problem

Hi everyone , i have question ,I spend many hours to find my problem without result , my machine cut over of .0125 in for every inch cut (ex : 2"= 2 1/4 , 1"=1 1/8) , i double check mach 3 and also check if each displament are exacly the same in mach3 and on the machine . I also check on s...