Search found 5 matches
- Mon Mar 23, 2020 2:47 am
- Forum: Problems and questions
- Topic: Torch start position round plate
- Replies: 2
- Views: 808
Re: Torch start position round plate
right the heck on, thats awesome...thank you for that info!
- Mon Mar 23, 2020 1:34 am
- Forum: Problems and questions
- Topic: Torch start position round plate
- Replies: 2
- Views: 808
Torch start position round plate
I have different sizes of plate steel that are round circle shapes. I want my plasma torch to be in the center of the steel circle plate when I hit run... This way I can load a circle picture, move torch to center of plate 0.0...Then if my picture is 22 inches in dia. and the steel plate is 23 inche...
- Mon Mar 23, 2020 1:31 am
- Forum: Problems and questions
- Topic: Plasma Torch Finish Position
- Replies: 5
- Views: 4922
Re: Plasma Torch Finish Position
I solved allot of issues by reloading the complete program into table computer. Turns out previous owner may have tried unsuccefully at making changes before my purchase.
- Thu Jan 10, 2019 3:27 pm
- Forum: Problems and questions
- Topic: Plasma Torch Finish Position
- Replies: 5
- Views: 4922
Re: Plasma Torch Finish Position
Thank you to those that have given me direction. Sheetcam is an awesome program. After changing those settings (parking position tab) the torch completes the cutting and returns to the start position... then darts back to final cut position still. I am starting to think it could be mach 3 setting I ...
- Wed Jan 09, 2019 4:15 am
- Forum: Problems and questions
- Topic: Plasma Torch Finish Position
- Replies: 5
- Views: 4922
Plasma Torch Finish Position
I have been looking endlessly for the tab that controls where the plasma torch finishes at the end of the cutting. My old table the torch would start at the bottom left and finish in the exact same spot...I know where to change the starting orientation but not the final point of completion at the en...