sheetcam.com

I never had 11B, currently on 11M7?
Don't know if that's a good or bad think.
On small details I try and make put them on a layer I can control.

End Of Cut. Prevents the torch from diving when you turn off before the end.
You should not have it on for holes as you have the DTHC already disabled.

Also when I deleted one of the circle you had open vectors.

Is your DXF file 5 times a 6" cut or are you doing one 30" cut?
The single 30" cut should work fine.

I show six open vectors in the small half moon. the end caps are not connected to the arcs.

Try this. still a lot of work to do.

Like Steve, this Steve also had issues but I was able to download it. You have a lot of overlapping traces on that. what are you planing to cut it out with? Plasma? laser?

It doesn't open up in Corel very well either. Lots of issues. Can you save it as a SVG?
Had better luck

If you want to add it to the post processor then you should talk with Tom at CandCNC. He wrote the post.

I have had the same issue. I was also told that DXF doesn't really have a true standard.
Can you export it as a SVG file? I have had much better luck going that route.

Dan At LDR found the problem. It is with the CandCNC Post Processor 11D (and some others) Here is his fix (tested it and it fixed it) Re: Not scribing first line if scribing only? Postby dhelfter » Fri Oct 09, 2015 1:38 pm Finally had some time to revisit this issue. Was working on the post processo...

Here is the Job that I need to get done. If i run the scribe tool it doesn't turn on the scribe on two the the lines of the two triangles. If i use a torch as the tool, it runs fine.

Here are some screen prints of Mach3 not liking the post.
I have tried SC 6.0.15 and 6.1.21. I have also tried other posts.
Currently using DTHCIV 11D

The inside square box has no bottom on the non leadin tap. The Z moves over to the right lower side of the box does not turn on the scriber until it starts its vertical climb on the left.
Does the same thing in real life.

There seems to be an issue with the plate marker tool. Here are the same job, one with a .001 leadin on the plate marker and one without (normal) You will note that even in your simulation program you loose the first horizontal line with no leading. I was having this issue on a larger project and na...