sheetcam.com

Sorry Les. After a while I don t think rules or tools are changing. Save and load will do. Thanks for the link.
Problems always occur when it can t happen. I stick to the normal route.

Sorry for the stupid question, save toolset and it's complete with rules. Super.

All right, playing with rules for a few weeks now. Very nice! Now, sorry but there's another question. Since I work with two computers, one in the house and one in the shop, is it possible that sheetcam loads the post from a central harddisk (nas) and also the rules? Everywhere I work is the same g-...

Thanks Les, the first video is very interesting. I will take a good look when there is more time. Since there is a z-axis with thc on the plasma table everything is much more complex then a rollerhead. Cutting quality is jumping forward. Thanks.

Ok, wrote m101 and m102 thc on and off in mach3, crtl c crtl v. And it works. Long live internet. Tried some coding in Sheetcam but that is a little unclear. For now different layers is fine, short lead in for the holes and long for the rest of the plate. What is the easy way to change the post? I e...

Thanks a lot. Let s see if there are some video s

Thanks, just tried the different layer metod and it's not to bad. For changing current I probably need a rs485 for the powermax? Turn thc off? How? The postprocessor we use is plasma MP1000-THC post processor with engraver.

Hello, another question. Is it possible to switch off thc while cutting holes? Next step, reduce amp in g-code (with a little luck, this is used in Edingcnc) Or otherwise: how do you guys cut small holes? Surfing internet a lot, frequently asked, but all old posts with different layers etc, sounds a...

Thanks a lot. I overlooked this one. With a program like sheetcam I knew it was something easy. Thanks a lot, it saves me a lot of time.

Hello, this is my first question, after saying that Sheetcam is a super program. Like in the title, after cutting the bridge goes to the parking position and then to the origin instead of staying in the parking position. I dont want to remove all x0 y0 in the g code program. There must be another, v...