Thanks les
That was the problem
Gary
Search found 5 matches
- Fri Aug 30, 2019 11:26 pm
- Forum: Problems and questions
- Topic: Z start to high
- Replies: 6
- Views: 963
- Sat Aug 24, 2019 5:54 pm
- Forum: Problems and questions
- Topic: Z start to high
- Replies: 6
- Views: 963
Re: Z start to high
Here is the job file
Thanks gary
Thanks gary
- Thu Aug 22, 2019 6:13 pm
- Forum: Problems and questions
- Topic: Z start to high
- Replies: 6
- Views: 963
Re: Z start to high
Thanks Yes I have checked that I had it at 0 and also at.250 its on a mill so I like it at .250 above table... Doesn't seem like any setting I change it always writes out the g code to start at 3.5" high and just thinks that the Hight to work from it should jog to .5 then down to 0 and start cu...
- Wed Aug 21, 2019 9:12 pm
- Forum: Problems and questions
- Topic: Z start to high
- Replies: 6
- Views: 963
Z start to high
I can't seem to get the Z to start at top of part with the development ver. it always seems to set the Z to start from 3.5 inches so its cutting air..
I have the same post processor and part in The release version and that starts at the correct Z start and cuts fine..
any suggestions
Thanks
I have the same post processor and part in The release version and that starts at the correct Z start and cuts fine..
any suggestions
Thanks
- Mon Apr 22, 2019 1:42 pm
- Forum: Problems and questions
- Topic: Rehashing old hole not found problem
- Replies: 1
- Views: 622
Rehashing old hole not found problem
I know this has been gone over many times but I can't seem to get it fixed, It only seems to happen if I try to drill twice with the same hole.. If I create a drill process for the hole say to do a spot drill, the drill bit is .125 and create it, I get no errors. now if I pick the same hole and swit...