(Filename: 20in line.tap) (Post processor: CandCNCPlasmaLLCNC-rev26.scpost) (Date: 01/04/19) G20 (Units: Inches) F10.0 G90 G40 G64 P0.010 Q0.001 (tracking tolerances set to 0.01) M68 E0 Q10 (Part: 20in line) (Operation: No Offset, 0, T29: 85 amp 1/4 steel) M68 E0 Q900 (Global DTHC ON/OFF is ON ) G4 P.1 M68 E0 Q89 (Auto Preset is not active ) G4 P.1 (Preset Volts: 123) (Preset AMPS: 85) ( Air Pressure Preset: 75) ( Soft pierce is off ) ( Suggested Tip Size: 85 ) ( DTHC Delay: 1 sec ) ( Min Cut Length for DTHC ON : 1 units ) M68 E0 Q3123 (Preset Volts set to 123 Volts) G4 P.1 M68 E0 Q485 ( Preset Amps set to 85 Amps) G4 P.1 M68 E0 Q875 ( Air pressure set to 75 PSI) G4 P.1 M68 E0 Q510 (DTHC Delay set to 1 Seconds) G4 P.1 M68 E0 Q10 (DTHC is OFF) G4 P.1 (MSG, The PAUSE after this message is to allow the Operator to check the DTHC settings to confirn they are loaded from the G-Code and are correct. If you need to change anything do it before you hit the RESUME button to continue) M1 G0 Z0.787 X0.000 Y0.000 G0 Z0.39 o call (external Touch off from Commandcnc) G1 X0.000 Y0.000 G0 Z0.150 M3 S100 G1 X19.435 Z0.060 F120.0 M67 E0 Q10 (DTHC OFF) X20.000 (End of job , noving to predefined Parking position) G0 Z0.787 M68 E0 Q900 M68 E0 Q10 (DTHC is off) G4 P.2 M5 M30