Offset adjustment?
Posted: Thu Sep 09, 2021 3:32 pm
Hi Les,
Keep wondering about this if it is possible at all?
Could be a useful feature.
Supposing when you select inside or the outside offset there was a entry box to make an adjustment to that by a certain amount.
ie: selecting inside offset with 1mm adjustment would make the hole 2mm smaller, same goes for outside offset on parts, I know you can do it by updating drawing, this would speed it up though.
Only a idea,
Keep wondering about this if it is possible at all?
Could be a useful feature.
Supposing when you select inside or the outside offset there was a entry box to make an adjustment to that by a certain amount.
ie: selecting inside offset with 1mm adjustment would make the hole 2mm smaller, same goes for outside offset on parts, I know you can do it by updating drawing, this would speed it up though.
Only a idea,