Sheetcam G-code not working with Mach3
Posted: Tue Nov 14, 2017 6:23 pm
Hard drive died and had to reinstalled Sheetcam and Mach3.
Thought it was Mach3 but it's sheetcam.
I found that SHEETCAM is not saving the G-codes (now) properly. I have some older G-codes that run just fine and the new G-codes are not running properly (running in MACH3 the torch on/off doesn't work automatically)
I have all the OLD programs MACH3 and Sheetcam installed them without updates and then ran them with updates. same problem
If there are someone out there that has any Ideas how to fix this
THANKS
Kevin
Thought it was Mach3 but it's sheetcam.
I found that SHEETCAM is not saving the G-codes (now) properly. I have some older G-codes that run just fine and the new G-codes are not running properly (running in MACH3 the torch on/off doesn't work automatically)
I have all the OLD programs MACH3 and Sheetcam installed them without updates and then ran them with updates. same problem
If there are someone out there that has any Ideas how to fix this
THANKS
Kevin