Radius to end of arc differs from radius to startline

Having problems with or questions about SheetCam? Post them here.
Post Reply
Ktown
Posts: 2
Joined: Sun Dec 04, 2016 12:26 am

Radius to end of arc differs from radius to startline

Post by Ktown »

I am getting the following error when I try and run some DXF files "radius to the end of the arc differs from the radius to the start 2508. I did a search and most suggest ij mode incremental I did this but it than just moves to a different line with the same error. I am at a loss of how to fix this issue.
I have attach a copy of the G code I am running and the DXF file and the post processor I am running in sheetcam

thanks in advance for the help.

Mike
Attachments
garage2.tap
(160.43 KiB) Downloaded 131 times
post.txt
(4.53 KiB) Downloaded 144 times
dads repair shop.dxf
(492.96 KiB) Downloaded 157 times
Post Reply