Tapping head/Rigid tapping not functioning?
Posted: Wed Aug 30, 2017 2:16 pm
Want to tap M16x2 and LinuxCNC or EMC posts following.
N0010 (Filename: tapping test.ngc)
N0020 (Post processor: EMC.scpost)
N0030 (Date: 30/08/2017)
N0040 G21 (Units: Metric)
N0050 G40 G90
N0060 F1
N0070 (Part: tapping test)
N0080 (Operation: Tap, 0, T6: Rigid tap, 16 mm x 2 mm, 20 mm Deep)
N0090 M6 T6 (Rigid tap, 16 mm x 2 mm)
N0100 G43 H6
N0110 G00 Z1.0000
N0120 M03 S150
N0130 M05
N0140 M05 M30
Is this still a problem after several years??
N0010 (Filename: tapping test.ngc)
N0020 (Post processor: EMC.scpost)
N0030 (Date: 30/08/2017)
N0040 G21 (Units: Metric)
N0050 G40 G90
N0060 F1
N0070 (Part: tapping test)
N0080 (Operation: Tap, 0, T6: Rigid tap, 16 mm x 2 mm, 20 mm Deep)
N0090 M6 T6 (Rigid tap, 16 mm x 2 mm)
N0100 G43 H6
N0110 G00 Z1.0000
N0120 M03 S150
N0130 M05
N0140 M05 M30
Is this still a problem after several years??