Negative Cut-Off
Posted: Mon Jul 10, 2017 9:17 pm
Hi
Is there any way to set a negative cut off at the end of a cut?
trying to get rid of a small divot on cut holes on underside only.
my plasma cutter takes anywhere up to 0.25 second from m05 code to actually turning off... have read that best way to get rid of divot is to have negative cut off so that plasma fully extinguishes at the point where kerf crosses....
any help appreciated!!
cheers,
-aaron
Is there any way to set a negative cut off at the end of a cut?
trying to get rid of a small divot on cut holes on underside only.
my plasma cutter takes anywhere up to 0.25 second from m05 code to actually turning off... have read that best way to get rid of divot is to have negative cut off so that plasma fully extinguishes at the point where kerf crosses....
any help appreciated!!
cheers,
-aaron