Torch Dismount - Same Place in File Run
Posted: Mon Jul 03, 2017 9:02 pm
Hi All,
I am trying to run the attached file and it all goes smoothly until it gets to cutting the letter M, E or H. The first time, I thought that the torch came out of the magnetic base as a result of a tip up, but not so. When I tried it the second time, assuming all would be okay, the same thing happened. Sooooo, I ran it one more time in order to confirm that saying about the "Definition of Insanity", but this time I watched closely as the torch seemed to drag on the steel without liftoff and then pop out of the mount.
Can someone see if there is anything in the code that is causing this? I neglected to look at the screen to see which code line area it is.
Thank you,
Steve
I am trying to run the attached file and it all goes smoothly until it gets to cutting the letter M, E or H. The first time, I thought that the torch came out of the magnetic base as a result of a tip up, but not so. When I tried it the second time, assuming all would be okay, the same thing happened. Sooooo, I ran it one more time in order to confirm that saying about the "Definition of Insanity", but this time I watched closely as the torch seemed to drag on the steel without liftoff and then pop out of the mount.
Can someone see if there is anything in the code that is causing this? I neglected to look at the screen to see which code line area it is.
Thank you,
Steve