G38.2 Move Finished Without Making Contact
Posted: Sun Jul 02, 2017 2:49 pm
Hi,
I am trying to cut this part in CommandCNC and keep getting this error on the first move. Prior to the attempt, I have moved the torch to the desired start point, zeroed the X & Y, did a Z Home and Z zero and then tried to cut. I have tried this with the torch turned off too and no difference. Any suggestions are greatly appreciated.
I am trying to cut this part in CommandCNC and keep getting this error on the first move. Prior to the attempt, I have moved the torch to the desired start point, zeroed the X & Y, did a Z Home and Z zero and then tried to cut. I have tried this with the torch turned off too and no difference. Any suggestions are greatly appreciated.