Page 1 of 1
Not getting a m03 or m05
Posted: Fri Jun 23, 2017 10:36 am
by cody
Hello I am very new to this type of programming and trying to teach myself...I built a homemade plasma table and everything is good but I am not getting a m03 code to trigger my torch
Posted: Fri Jun 23, 2017 11:33 am
by Les Newell
What post processor are you using? If you aren't sure you can find it in Options->machine->post processor. If you are using a milling/routing post you won't get the correct M3/M5 codes
Posted: Tue Nov 21, 2017 1:12 pm
by Darrell Hoath
Hi Cody I’m having the same problem I’m new to this and I’m using an arduino grbl shield. Some post processors move the plasma torch correct but I can’t seem to find one that fires the torch did you find an answer or a post processor for grbl ? Also are you using Mach or something else I’m using laserweb and I did have it working before I perched sheetcam but now it’s not [/quote]