Not getting a m03 or m05
Not getting a m03 or m05
Hello I am very new to this type of programming and trying to teach myself...I built a homemade plasma table and everything is good but I am not getting a m03 code to trigger my torch
- Les Newell
- Site Admin
- Posts: 3661
- Joined: Thu May 11, 2006 8:12 pm
-
- Posts: 1
- Joined: Tue Nov 21, 2017 4:05 am
Hi Cody I’m having the same problem I’m new to this and I’m using an arduino grbl shield. Some post processors move the plasma torch correct but I can’t seem to find one that fires the torch did you find an answer or a post processor for grbl ? Also are you using Mach or something else I’m using laserweb and I did have it working before I perched sheetcam but now it’s not [/quote]