No Code Generated!

chemosavi · Post by **chemosavi** » Tue Jun 06, 2017 7:39 am

After using Sheetcam for three years all of a sudden it stopped generating any Tap code. No other changes have occurred. Same computer, same machine, etc.
Says my license file (camlic) is fine.
No matter what post processor I use it generates the same startup code with no cuts, nada. As below:
N0010 (Filename: washersT.tap)
N0020 (Post processor: Dynatorch.scpost)
N0030 (Date: 05/06/2017)
N0040 G20 (Units: Inches)
N0050 G90
N0060 G17
N0070 (Part: washers)
N0080 G25
N0090 M30

Does the license file expire after a few years?

HELP!!!!!!!!!

chemosavi · Post by **chemosavi** » Tue Jun 06, 2017 7:57 am

Strange. I kept a backup of my license file and once installed instead of the one that's been working for two years, Sheetcam is working fine. I did watch Twin Peaks on the computer while working the other day so maybe that had something to do with it.................
Thanks!

Post by **Les Newell** » Tue Jun 06, 2017 11:22 am

That sounds like you have a license that has been copied too many times. You may well find that the reinstalled license will stop working as well.

+Jan+ · Post by **+Jan+** » Tue Jun 06, 2017 12:09 pm

Hey,
we got the same Problem here. We have a mill here in our diy lab. The Licence is installed on different notebooks but only used for one mill. I`ve looked now in your licence and have seen, that licence is a single workplace licence and not a floating lincence.

Is there any possibility to get the lincence working on one pc again?

Best wishes,

Jan

Post by **Les Newell** » Tue Jun 06, 2017 12:29 pm

could you send me your license ID in a PM. You can find the ID in Help->about.

chemosavi · Post by **chemosavi** » Wed Jun 07, 2017 11:08 pm

The not so subtle implied instruction to be, do not make copies of your license!
Amazing piece of software.