After using Sheetcam for three years all of a sudden it stopped generating any Tap code. No other changes have occurred. Same computer, same machine, etc.
Says my license file (camlic) is fine.
No matter what post processor I use it generates the same startup code with no cuts, nada. As below:
N0010 (Filename: washersT.tap)
N0020 (Post processor: Dynatorch.scpost)
N0030 (Date: 05/06/2017)
N0040 G20 (Units: Inches)
N0050 G90
N0060 G17
N0070 (Part: washers)
N0080 G25
N0090 M30
Does the license file expire after a few years?
HELP!!!!!!!!!
No Code Generated!
- Les Newell
- Site Admin
- Posts: 3665
- Joined: Thu May 11, 2006 8:12 pm
Hey,
we got the same Problem here. We have a mill here in our diy lab. The Licence is installed on different notebooks but only used for one mill. I`ve looked now in your licence and have seen, that licence is a single workplace licence and not a floating lincence.
Is there any possibility to get the lincence working on one pc again?
Best wishes,
Jan
we got the same Problem here. We have a mill here in our diy lab. The Licence is installed on different notebooks but only used for one mill. I`ve looked now in your licence and have seen, that licence is a single workplace licence and not a floating lincence.
Is there any possibility to get the lincence working on one pc again?
Best wishes,
Jan
- Les Newell
- Site Admin
- Posts: 3665
- Joined: Thu May 11, 2006 8:12 pm