sheetcam.com

Posted: **Sat May 13, 2017 9:51 pm**

I've recently moved from Windows/Mach to Linux/CommandCNC. I cannot seem to get the grid lines to show up on the Linux version of Sheetcam. I've changed colors, type (dots vs lines), etc, and nothing. The rulers will show up, but no actual grid.

I use the grid on nearly every cut to nest parts together. What am I missing to get the grid lines to show up?

Thanks!

Posted: **Sat May 13, 2017 11:32 pm**

Make sure you are using the latest Linux version of Sheetcam. If I remember right, on the original version the grid didn't show up, but it was fixed on the latest version. (6.1.40)

Steve

Posted: **Mon May 15, 2017 4:16 am**

WyoGreen wrote:Make sure you are using the latest Linux version of Sheetcam. If I remember right, on the original version the grid didn't show up, but it was fixed on the latest version. (6.1.40)

Steve

That did it. Thanks!

sheetcam.com

Grid lines on Linux sheetcam?

Grid lines on Linux sheetcam?