Grid lines on Linux sheetcam?

Having problems with or questions about SheetCam? Post them here.
Post Reply
motoguy
Posts: 121
Joined: Sun May 01, 2016 12:02 am

Grid lines on Linux sheetcam?

Post by motoguy »

I've recently moved from Windows/Mach to Linux/CommandCNC. I cannot seem to get the grid lines to show up on the Linux version of Sheetcam. I've changed colors, type (dots vs lines), etc, and nothing. The rulers will show up, but no actual grid.

I use the grid on nearly every cut to nest parts together. What am I missing to get the grid lines to show up?

Thanks!
WyoGreen
Posts: 257
Joined: Wed May 07, 2014 10:02 pm

Post by WyoGreen »

Make sure you are using the latest Linux version of Sheetcam. If I remember right, on the original version the grid didn't show up, but it was fixed on the latest version. (6.1.40)

Steve
motoguy
Posts: 121
Joined: Sun May 01, 2016 12:02 am

Post by motoguy »

WyoGreen wrote:Make sure you are using the latest Linux version of Sheetcam. If I remember right, on the original version the grid didn't show up, but it was fixed on the latest version. (6.1.40)

Steve
That did it. Thanks!
Post Reply