Hole at end of arc

Having problems with or questions about SheetCam? Post them here.
Post Reply
jeff tunks
Posts: 6
Joined: Fri Mar 31, 2017 10:11 am

Hole at end of arc

Post by jeff tunks »

When I select an arc it cuts the arc fine but it leaves a burn hole when it begins the line I am cutting and then cuts the line fine?
WyoGreen
Posts: 257
Joined: Wed May 07, 2014 10:02 pm

Post by WyoGreen »

If this is an open line, you can try reducing your Pierce delay to minimize the divot.

Steve
Post Reply