Connecting tabs

Having problems with or questions about SheetCam? Post them here.
Post Reply
LittleBit
Posts: 3
Joined: Wed Nov 02, 2016 10:51 pm

Connecting tabs

Post by LittleBit »

Maybe someone could help me I lay .5 flat bar side by side then cut across the X axes making squares but at each seam there is a little tab that is still connected I have been told to use action points but when I try the machine slows down at the first triangle but does not speed up again why are there two triangles at the seam do I want one before and one after ? do I want two before and two after maybe there is some writings about this or video ? I draw in auto cad then Sheet cam then mach 3 HTPM 85

Thanks
Little Bit
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Post by Les Newell »

If you set the feed rate in an action point it will take effect between the strat of teh anction point and it's end (i.e between the two arrows).
Post Reply