need a simple post processor

stephenmmontes · Post by **stephenmmontes** » Mon Dec 19, 2016 3:40 pm

Hello,
Does anyone know of a simple post processor that only codes the M3 and M5 plus the coordinates? I am using a linux based system. I dont need Z axis. I tried the mach 3 no z post pro but complicated drawings are not lowering the cutter to the right height and firing in the air on a couple of cuts.

jim1108 · Post by **jim1108** » Fri Dec 23, 2016 9:10 pm

Try one of the minimal G-Code posts in your machine post processor tab. I think there are 3 or 4 of them.