TNG development V6.1.14 released
Posted: Wed Apr 22, 2015 12:13 pm
Hi all,
I have just uploaded V6.1.14 to www.sheetcam.com
Sorry for the long delay for this release. I have been woring on another
project over the last few months. That is now finished so I can get back
to SheetCam.
Fixed: Crashing on exit on some computers
Fixed: Hint icons being shown much too small.
Fixed: Save job and save job as icon swapped
Fixed: Sometimes not detecting arcs that have a very large radius and
very small included angle
Fixed: Rotary plasma plungin sometimes rotating 360 degrees when it
shouldn't
Changed: Mode menus now show as radio buttons instead of check boxes
Added: Option to delete contours
Fixed: sometimes generating incorrect leadins
Fixed: Editor not always showing correctly when a Lua macro throws an error
Fixed: Some tools showing incorrect hint icons
Added: Material name (Options->job options->material)
Fixed: Arcs with a huge radius and small included angle are converted to
lines
Added: 'Run post' button in post editor
Fixed: Overlapping rules sometimes not output correctly
Les
------------------------------------
Posted by: Les Newell <les.newell@fastmail.co.uk>
------------------------------------
------------------------------------
Yahoo Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/sheetcam/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/sheetcam/join
(Yahoo! ID required)
<*> To change settings via email:
sheetcam-digest@yahoogroups.com
sheetcam-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
sheetcam-unsubscribe@yahoogroups.com
<*> Your use of Yahoo Groups is subject to:
https://info.yahoo.com/legal/us/yahoo/utos/terms/
I have just uploaded V6.1.14 to www.sheetcam.com
Sorry for the long delay for this release. I have been woring on another
project over the last few months. That is now finished so I can get back
to SheetCam.
Fixed: Crashing on exit on some computers
Fixed: Hint icons being shown much too small.
Fixed: Save job and save job as icon swapped
Fixed: Sometimes not detecting arcs that have a very large radius and
very small included angle
Fixed: Rotary plasma plungin sometimes rotating 360 degrees when it
shouldn't
Changed: Mode menus now show as radio buttons instead of check boxes
Added: Option to delete contours
Fixed: sometimes generating incorrect leadins
Fixed: Editor not always showing correctly when a Lua macro throws an error
Fixed: Some tools showing incorrect hint icons
Added: Material name (Options->job options->material)
Fixed: Arcs with a huge radius and small included angle are converted to
lines
Added: 'Run post' button in post editor
Fixed: Overlapping rules sometimes not output correctly
Les
------------------------------------
Posted by: Les Newell <les.newell@fastmail.co.uk>
------------------------------------
------------------------------------
Yahoo Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/sheetcam/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/sheetcam/join
(Yahoo! ID required)
<*> To change settings via email:
sheetcam-digest@yahoogroups.com
sheetcam-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
sheetcam-unsubscribe@yahoogroups.com
<*> Your use of Yahoo Groups is subject to:
https://info.yahoo.com/legal/us/yahoo/utos/terms/