sheetcam.com

Hello i have been using sheetcam for my plasma table for 3 years and i love it (THANK YOU!!) So now i want to use it for my shapoko desktop mill but i don't know what post processor to use any help here would be appreciated
http://www.shapeoko.com/wiki/index.php/Software


my cotroller http://arduino.cc/en/Main/arduinoBoardUno
http://docs.shapeoko.com/electronics.html



Thanks


__._,_.___
Posted by: tomtorraville@yahoo.ca


Visit Your Group

Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use



__,_._,___

Try the minimum g-code post. It should be pretty close.

Les

On 02/09/2014 01:55, tomtorraville@yahoo.ca (tomtorraville@yahoo.ca) [sheetcam] wrote:

Hello i have been using sheetcam for my plasma table for 3 years and i love it (THANK YOU!!) So now i want to use it for my shapoko desktop mill but i don't know what post processor to use any help here would be appreciated 
 http://www.shapeoko.com/wiki/index.php/Software


my cotroller http://arduino.cc/en/Main/arduinoBoardUno
http://docs.shapeoko.com/electronics.html



Thanks 
 

__._,_.___
Posted by: Les Newell <les.newell@fastmail.co.uk>


Visit Your Group

• New Members 1

Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) &bull; Terms of Use



__,_._,___

Hi tomtorraville,

did you have any success with your Shapeoko and GRBL and Sheetcam?

Andrew