Identify Drawing Problems
Identify Drawing Problems
Often I get the message " not all cut paths generated correctly, there may be a problem with the drawing". Usually I can find these problems by looking at each pierce point and then sometimes I can see an extraneous small segment or a loop in a path. But for large files this becomes very tedious and even then sometimes I can't find any visible problem. When this happens I have to go back to Corel and selectively remove sections of the drawing and then go back to SheetCAM and see if the problem went away, if it does then I know the problem was in the section I removed. It would be nice if SheetCAM could somehow highlight what it thinks are problem areas in the drawing so I know where to look.
- Les Newell
- Site Admin
- Posts: 3665
- Joined: Thu May 11, 2006 8:12 pm