[REQUEST] Toggle overburn from start point properties.

Request and discuss new features
Post Reply
JohnB

[REQUEST] Toggle overburn from start point properties.

Post by JohnB »

Would it be possible to add turning on/off overburn from the "Properties" screen when editing start points?

Example: I have a square part with 4 holes. I use a "rule" to slow down and turn off DTHC w/ perpendicular lead-ins and a small overburn on the holes for a nice cut. I then select the OD cut start point and change the lead-in to an arc. Without the overburn, one could lead-in/out on a corner keeping it nice and "sharp", but with the overburn it tends to "round-off" the corner.

Yes, yes, I know. I could use layers (as I did before you added the awesome "rules" feature). I just wanted to be "lazy" and see if this could be added.

Thanks
JohnB

Post by JohnB »

Bumping this in case it wasn't noticed. Thanks
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Post by Les Newell »

I don't think this would be easy to add. I'll take a look but I can't give any guarantees.

Won't that give you three rounded corners and one sharp one?
Post Reply