I built a new table and I am using LinuxCNC software, with their Axis screenset. Which Post Processor would be the best to use. I have used the LinuxCNC plasmaC for the plasma operation, which works fine with QTPlasmaC. But I am having g-code issues planning a router operation in SheetCam.
This is one of the errors I get and also I get one about a tool error.
thanks in advance
What PP for LinuxCNC for router
- Les Newell
- Site Admin
- Posts: 3668
- Joined: Thu May 11, 2006 8:12 pm
Re: What PP for LinuxCNC for router
The PlasmaC post has a lot of PlasmaC specific stuff in it that LinuxCNC doesn't understand. Use the 'LinuxCNC' post for routing.
- acourtjester
- Posts: 17
- Joined: Sat Jun 15, 2013 8:29 pm
Re: What PP for LinuxCNC for router
Thanks for the reply I will try that