I'm running a Super-B with software version 7.0.0.242, and SheetCam vr 7.0.16
I'm using the Dynatorch post.
I just added the Dynascribe and got it working pretty good.
Currently, I'm setting up different layers and operations for scribe and cutting. When I bring it in to DT to cut, I have to manually lower the torch within 1/2" of the plate to be scribed (on the advice from Russell, I was told by another user that Leon mentioned the same), and then start cycle. All scribe operations start then cut operations.
There are times that I forget to lower the torch before start cycle and the scribe runs but since I forgot to lower the torch no scribing took place, but the cut operation completed.
Is there a way to setup the post to use ohmic sensing to touch off the plate then retract 1/2" to begin the scribe/cut operation?
In my post list I have the following:
- Dynatorch
- Dynatorch no feed
- Dynatorch old
- Dynatorch pierce starts
- Dynatorch router
- Dynatorch2
Thanks for your help.