Half a hole showing up
Half a hole showing up
I seem to have developed an issue. I use inkscape for drawing up files. I make sure of no open lines. Save the file. Bring it into sheetcam and only half of the hole shows up. Has done this on three different files tonight. I have deleted the hole renamed it saved the file. Opened a new window brought the newly renamed file in added a new hole. Took it to sheetcam to show up the same way. Only half a hole. Any ideas?
- Attachments
-
- EF1D3449-9440-4BB9-B380-220690BA6675.jpeg (1.02 MiB) Viewed 775 times
-
- 5905834F-B4FC-4B86-B6EC-5EF6D49F053F.jpeg (1.83 MiB) Viewed 775 times
-
- 952F5F9A-BC7B-4D0B-A1D0-EE4A6E30BD55.jpeg (1.72 MiB) Viewed 775 times
Re: Half a hole showing up
Ok i figured it out. I’m not sure if its an issue with inkscape or sheetcam. One of them will not recognize a .750 hole. I dropped down to .625 and it showed up full circle.
-
Les Newell
- Site Admin
- Posts: 3687
- Joined: Thu May 11, 2006 8:12 pm
Re: Half a hole showing up
Do you still have the problem drawing? If so could you send it to me.