Scananything for linux/CommandCNC?
Scananything for linux/CommandCNC?
I'm currently running CandCNC Bladerunner Ethercut DTHCIV system. I'm interested in moving to the linux/CommandCNC system. I'm curious if there is a version of Scananything that works with the CandCNC offering. If not, is there an ETA for such a critter?
I currently use Scananything on my Mach based setup, and would hate to lose that functionality.
Thanks!
I currently use Scananything on my Mach based setup, and would hate to lose that functionality.
Thanks!
- Les Newell
- Site Admin
- Posts: 3675
- Joined: Thu May 11, 2006 8:12 pm
- Les Newell
- Site Admin
- Posts: 3675
- Joined: Thu May 11, 2006 8:12 pm
Awesome. I'm actually running Mach/Windows right now. I've been holding off on the upgrade until Scananything was available for Linux / CommandCNC.
However, per https://www.candcnc.com/supportforum/vi ... 9875#p9875, the upgrade from Windows to Linux just got more expensive. Went from $450 to $550, and will be the full $1150 after 90 days.
So, I'm going to go ahead an upgrade without Scananything...but it would be nice to know how soon I can use it again.
However, per https://www.candcnc.com/supportforum/vi ... 9875#p9875, the upgrade from Windows to Linux just got more expensive. Went from $450 to $550, and will be the full $1150 after 90 days.
So, I'm going to go ahead an upgrade without Scananything...but it would be nice to know how soon I can use it again.
- Les Newell
- Site Admin
- Posts: 3675
- Joined: Thu May 11, 2006 8:12 pm
- Les Newell
- Site Admin
- Posts: 3675
- Joined: Thu May 11, 2006 8:12 pm
- Les Newell
- Site Admin
- Posts: 3675
- Joined: Thu May 11, 2006 8:12 pm