hole at end of cure

Having problems with or questions about SheetCam? Post them here.
Post Reply
jeff tunks
Posts: 6
Joined: Fri Mar 31, 2017 10:11 am

hole at end of cure

Post by jeff tunks »

I have a burn every place the curve or the perpendicular line connect with the polygon art from the DXF I am cutting? The burn is a hole in the stock about twice the width of the kerf. Thank. Jeff Tunks
WyoGreen
Posts: 257
Joined: Wed May 07, 2014 10:02 pm

Post by WyoGreen »

It sounds like you are getting a pause at each place. Have you watched the torch as it's cutting to see if you get a small pause. I wonder if maybe the lines are not all joined, and Sheetcam is seeing them as separate cuts?

Steve
Post Reply