I have used Sheetcam for over 12 months with no problems, from this afternoon when I loaded various parts and run Simulation, all I get is (Warning: feed rate is zero) I have tried re-loading Sheetcam, checked my options etc., nothing seems to work.
Regards.
Warning: feed rate is zero
-
- Posts: 20
- Joined: Fri May 13, 2016 1:01 pm
- Location: South Yorkshire
Warning: feed rate is zero
- Attachments
-
- Capture.JPG (33.88 KiB) Viewed 5399 times
- Les Newell
- Site Admin
- Posts: 3661
- Joined: Thu May 11, 2006 8:12 pm
Same Problem
Hi Les
This is the same problem that i have.
I sent my licence number late this afternoon using the SheetCam "Create a Support File" option.
I will send it again via PM
Hope we can get this sorted out asap
Thanks
Regards
Dunk
This is the same problem that i have.
I sent my licence number late this afternoon using the SheetCam "Create a Support File" option.
I will send it again via PM
Hope we can get this sorted out asap
Thanks
Regards
Dunk