Having problems with or questions about SheetCam? Post them here.
Alabass
Posts: 8 Joined: Tue May 23, 2017 1:11 pm
Post
by Alabass » Thu May 25, 2017 2:20 pm
How do you know which post processor to use for basic plasma cutting?
WyoGreen
Posts: 257 Joined: Wed May 07, 2014 10:02 pm
Post
by WyoGreen » Thu May 25, 2017 2:58 pm
It depends on your equipment. What plasma cutter, what plasma table controller, etc. If you post what you have, we can advise you on what processor you need.
Alabass
Posts: 8 Joined: Tue May 23, 2017 1:11 pm
Post
by Alabass » Thu May 25, 2017 4:44 pm
I have a Thermal Dynamics Cutmaster 38 plasma cutter. I'm using Mach3 software. I have a Proma Compact THC but haven't got it set up to work yet.
Thanks
WyoGreen
Posts: 257 Joined: Wed May 07, 2014 10:02 pm
Post
by WyoGreen » Fri May 26, 2017 5:03 pm
There are a number of Mach3 plasma posts. You could start out with the plain Mach3 plasma post. I'm not real sure what the Proma THC needs, but when you get to that point you might try the Mach3 plasma with THC.
Steve
Alabass
Posts: 8 Joined: Tue May 23, 2017 1:11 pm
Post
by Alabass » Fri May 26, 2017 7:25 pm
Thanks. I'm playing around with it right now.
dennisshaw
Posts: 20 Joined: Fri May 13, 2016 1:01 pm
Location: South Yorkshire
Post
by dennisshaw » Fri May 26, 2017 10:28 pm
Hello,
Just ask Les, he will let you know he is the Top Man.
Regards.
Alabass
Posts: 8 Joined: Tue May 23, 2017 1:11 pm
Post
by Alabass » Tue May 30, 2017 7:12 pm
Yes, Les helped me out. Thanks!