Sheetcam 6.0.23 and Mach 3

Having problems with or questions about SheetCam? Post them here.
Post Reply
plsmatech
Posts: 4
Joined: Sat Apr 08, 2017 6:54 am

Sheetcam 6.0.23 and Mach 3

Post by plsmatech »

Everything working fine unil cutting circles Sheetcam simulator running fine and then running tap file in Mach 3
Seems like Mach 3 is not recodnizing some of the code
Will add postproceesor file and tap file

Help
Plsmatech
Attachments
Patrick 5 MP1000-THC-Fan on piercecount.post
(4.86 KiB) Downloaded 81 times
gasket25.tap
(2.29 KiB) Downloaded 82 times
plsmatech
Posts: 4
Joined: Sat Apr 08, 2017 6:54 am

See photos

Post by plsmatech »

Please see photographs
Image
Attachments
perfect in Sheetcam
perfect in Sheetcam
Gasket01.jpg (26.26 KiB) Viewed 1334 times
Gasket02.jpg
Gasket02.jpg (87.6 KiB) Viewed 1334 times
No good in Mach 3
No good in Mach 3
Gasket03.jpg (19.19 KiB) Viewed 1334 times
WyoGreen
Posts: 257
Joined: Wed May 07, 2014 10:02 pm

Post by WyoGreen »

I'd try changing your Sheetcam job. First, I'd move the outside circle to it's own layer. Then I'd set up an operation to cut the layer the 5 inside holes are on as an inside offset cut. Next I'd set up an operation to cut the layer the outside circle is on as an outside offset cut. I think that will clear up the problem you are having.

Steve
plsmatech
Posts: 4
Joined: Sat Apr 08, 2017 6:54 am

Post by plsmatech »

Thanks Steve but it was a Post Processor Problem
Old post not compatible with new Sheetcam TNG
Post Reply