Rotary Plasma Plug-in

Having problems with or questions about SheetCam? Post them here.
Post Reply
jim1108
Posts: 74
Joined: Sat Oct 29, 2016 1:19 pm
Location: New Mexico, USA

Rotary Plasma Plug-in

Post by jim1108 »

I am playing with the rotary plasma plug-in on a Fanuc milling machine using a Rotary Mach 3 post processor. The plug in works great after some minor code editing for radial milling or engraving. I wanted to know if there is a way to only show one layer in the rotary simulation mode. When the simulation is run, it shows all layers, but correctly machines the selected layer. It can be a little confusing when all the layers are wrapped around a circular object and you only need to view the post processor of one layer.
Attachments
HEADS,TAILS.job
(22.3 KiB) Downloaded 169 times
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Post by Les Newell »

That is a very good point. I'm afraid SheetCam you can't do that. I'll add it to the to-do list.
Post Reply