Im setting up a new PC and I have a Sheetcam Liscense.
When I go to downloads on the website and click the ''DownLoad Sheetcam Linux 64 bit and 32 bit" link, I get a page full of symbols and other stuff..
No prompt box from the OS that asks where to put it etc> as I do if i click the Download sheetcam under the Windows OS header on the webpage.
Is the link broken?
Installing sheetcam on Linux Mint/ Download tab broken?
-
- Posts: 3
- Joined: Fri Jan 13, 2017 11:58 pm
-
- Posts: 3
- Joined: Fri Jan 13, 2017 11:58 pm
I'd like to say Thanks Les!
I've downloaded and used the latest Linux Sheetcam update (6.1.39) for a couple of days now.
This latest update fixed several of those little issues I've been having. The grids now show up, and the tool table doesn't crash anymore upon closing.
Again, Thanks Les for your hard work, Steve
I've downloaded and used the latest Linux Sheetcam update (6.1.39) for a couple of days now.
This latest update fixed several of those little issues I've been having. The grids now show up, and the tool table doesn't crash anymore upon closing.
Again, Thanks Les for your hard work, Steve
-
- Posts: 3
- Joined: Fri Jan 13, 2017 11:58 pm
So its working now? Ill try it again but i had no luck the other day..WyoGreen wrote:I'd like to say Thanks Les!
I've downloaded and used the latest Linux Sheetcam update (6.1.39) for a couple of days now.
This latest update fixed several of those little issues I've been having. The grids now show up, and the tool table doesn't crash anymore upon closing.
Again, Thanks Les for your hard work, Steve
My sheetcam crashes when loaded down too so im hopefull this will download and install now.. and 1 thing, i purchased my liscense through CandCNC. where is the lic #or whatnot found to enter into this new pc?