MP1000 thc

Having problems with or questions about SheetCam? Post them here.
Post Reply
bteigrob
Posts: 6
Joined: Wed Dec 02, 2015 8:31 pm

MP1000 thc

Post by bteigrob »

Hello everyone. so i had a computer crash on me. So got a new one and installed sheetcam and mach3. we used the MP1000 thc post processor, and I am using that again and set the switch offset and ref distance same as the old one. but now the machine will not go down till the digitized switch and reset to zero, go up the distance of the switch, reset to zero and then go up to the pierce height. It goes down to .5020 off the steel, sets that at zero and goes up the distance of the swtich and then goes up another distance which is pierce height. What am i missing then the G28.1 doesn't make the head go down till the digitized switch tells it to stop. I had it working very nice on the old pc but can't remember what i did so i can configure this new one. Any help is appreciated. Thanks
Post Reply