sheetcam.com Forum Index sheetcam.com
SheetCam discussion board
 
 Forum SubscriptionsForum Subscriptions    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Second Flame profile question

 
Post new topic   Reply to topic    sheetcam.com Forum Index -> Yahoo posts (yahoo @forum.sheetcam.com)
View previous topic :: View next topic  
Author Message
steve@adnaironworks.co...
Guest





PostPosted: Tue May 12, 2015 6:19 am    Post subject: Second Flame profile question Reply with quote

Hi Les, I have been wanting to have a second profile set up for flame cutting with Sheet-cam so I don't have to change the post processor and tool sets, is there a way to do this without a lot of confusion?
I have been using TNG for flame and TNG Development for plasma but I'd like the features of the development version for flame cutting.
I remember seeing something about it a while back but didn't quite understand how to make it work, could you explain it for a dummy?!


Thanks, Steve

__._,_.___
Posted by: steve@adnaironworks.com
[img]http://geo.yahoo.com/serv?s=97476590/grpId=12675264/grpspId=1705007389/msgId=16764/stime=1431411545[/img]

Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use



__,_._,___
Back to top
Display posts from previous:   
Post new topic   Reply to topic    sheetcam.com Forum Index -> Yahoo posts (yahoo @forum.sheetcam.com) All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You can attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group